Tamarack Solar 90798 Ground Mount 4 Module First Column Kit for use with 3.1 inch Rail Tamarack

Tamarack Solar 90798 Ground Mount 4 Module First Column Kit for use with 3.1 inch Rail

The Tamarack Ground Mount System is assembled using 3.1 rail with 2-inch schedule 40 or 80 galvanized steel pipe that is purchased separately.

Use four 66-inch rails and two structural splices per column to create two 132-inch rail assemblies for 3 modules per column.

Use four 85-inch rails and two structural splices per column to create two 170-inch rail assemblies for for 4 modules per column.

The maximum PV module width is 41.5- inches on 4 module columns and 43 inches on 3 module columns.

The system comes with all parts needed except for the 2-inch pipe and concrete. Assembly is quick and easy and can be used on almost any terrain.

• Simple Design – Arrays can be in columns of 3 or 4 module high and any width required
• Easy to install – No welding or drilling and two wrench sizes fit all fasteners
• UL 2703 Listed – All components meet the UL 2703 standards for bonding and grounding
• PE Certified – Pre-stamped engineering letters available for most states
• Easy to configure – Unlimited system size with tilt angles from 0 to 45 degrees
• Visually Appealing – Simple to adjust for perfect alignment, even if the surface is irregular
• Simple Wire Management – PV cables and wiring for module-level electronics fits inside rails to avoid time-consuming wire management
• Extremely Robust – For use in locations with wind speeds up to 170 MPH and ground snow loads of up to 50 PSF

Parts included in the Tamarack Solar Ground Mount 4 Module First Column Kit:

• Four 85″ rails
• Four 2″ T-Fittings
• Two splices
• Four pipe mount clamps
• Ten 5050 clamps
• Four end caps
• Eight wire clips
• One ground clamp

Still Have Questions? Give us a call today 1-877-242-2792